Network Appliance NS0-502 덤프자료

ITExamDump의Network Appliance인증 NS0-502덤프공부가이드에는Network Appliance인증 NS0-502시험의 가장 최신 시험문제의 기출문제와 예상문제가 정리되어 있어Network Appliance인증 NS0-502시험을 패스하는데 좋은 동반자로 되어드립니다. Network Appliance인증 NS0-502시험에서 떨어지는 경우Network Appliance인증 NS0-502덤프비용전액 환불신청을 할수 있기에 보장성이 있습니다.시험적중율이 떨어지는 경우 덤프를 빌려 공부한 것과 같기에 부담없이 덤프를 구매하셔도 됩니다.

Network Appliance인증NS0-502시험을 패스하여 자격증을 취득한다면 여러분의 미래에 많은 도움이 될 것입니다.Network Appliance인증NS0-502시험자격증은 it업계에서도 아주 인지도가 높고 또한 알아주는 시험이며 자격증 하나로도 취직은 문제없다고 볼만큼 가치가 있는 자격증이죠.Network Appliance인증NS0-502시험은 여러분이 it지식테스트시험입니다.

ITExamDump을 선택함으로 100%인증시험을 패스하실 수 있습니다. 우리는Network Appliance NS0-502시험의 갱신에 따라 최신의 덤프를 제공할 것입니다. ITExamDump에서는 무료로 24시간 온라인상담이 있으며, ITExamDump의 덤프로Network Appliance NS0-502시험을 패스하지 못한다면 우리는 덤프전액환불을 약속 드립니다.

Network Appliance인증NS0-502시험을 위하여 최고의 선택이 필요합니다. ITExamDump 선택으로 좋은 성적도 얻고 하면서 저희 선택을 후회하지 않을것니다.돈은 적게 들고 효과는 아주 좋습니다.우리ITExamDump여러분의 응시분비에 많은 도움이 될뿐만아니라Network Appliance인증NS0-502시험은 또 일년무료 업데이트서비스를 제공합니다.작은 돈을 투자하고 이렇게 좋은 성과는 아주 바람직하다고 봅니다.

Network Appliance NS0-502인증시험은 전문적인 관련지식을 테스트하는 인증시험입니다. ITExamDump는 여러분이Network Appliance NS0-502인증시험을 통과할 수 잇도록 도와주는 사이트입니다. 많은 분들이 많은 시간과 돈을 들여 혹은 여러 학원 등을 다니면서Network Appliance NS0-502인증시험패스에 노력을 다합니다. 하지만 우리ITExamDump에서는 20시간 좌우만 투자하면 무조건Network Appliance NS0-502시험을 패스할 수 있도록 도와드립니다.

시험 번호/코드: NS0-502

시험 이름: Network Appliance (NetApp Certified Implementation Engineer-SAN and Virtualization)

NS0-502 덤프무료샘플다운로드하기: http://www.itexamdump.com/NS0-502.html

NO.1 What are three relevant perfstat counters to check for unaligned I/O that do not fall on the WAFL
boundary? (Choose three.)
A. wp.partial_write
B. vvol_read.io_valid
C. read/write_align_histo.XX
D. read/write_partial_blocks.XX
E. xinode content misses
Answer: ACD

Network Appliance   NS0-502   NS0-502인증   NS0-502

NO.2 An organization currently has a NetApp Fibre Channel block-based solution. With limited budget and
resources, they want to create a new disaster recovery site that utilizes a NetApp solution.
What would the optimal solution include?
A. SnapMover and Fibre Channel at the disaster recovery site for all hosts
B. SnapMirror and iSCSI at the disaster recovery site for all hosts
C. Fibre Channel at both locations using ftp to replicate storage
D. MetroCluster and NAS
Answer: B

Network Appliance   NS0-502   NS0-502   NS0-502   NS0-502

NO.3 A company has a Fibre Channel environment and wants to connect a new host in a remote data
center using 50/125um OM2 multi-mode fiber cable and needs to support 2 Gb speeds.
What is the maximum distance of the cable run supported in this situation?
A. 50/125um OM2 multi-mode fiber cable supports up to 500 meters at 2 Gb.
B. 50/125um OM2 multi-mode fiber cable supports up to 10000 meters at 2 Gb.
C. 50/125um OM2 multi-mode fiber cable supports up to 150 meters at 2 Gb.
D. 50/125um OM2 multi-mode fiber cable supports up to 300 meters at 2 Gb.
Answer: D

Network Appliance인증   NS0-502자격증   NS0-502기출문제   NS0-502 dumps

NO.4 Which three protocols can be used for communications between a host running SnapDrive for
Windows and the NetApp Storage Controllers? (Choose three.)
A. http:
B. https:
C. ftp:
D. RPC
E. ssh
Answer: ABD

Network Appliance   NS0-502기출문제   NS0-502   NS0-502

NO.5 A 200-GB LUN is created in an empty 500-GB volume with the volume guarantee option set to Volume.
LUN reservation is enabled and the fractional reserve is set to 100 and scheduled snapshots are
disabled.
Directly after LUN creation, what is the maximum free space available in the volume?
A. 200 GB
B. 300 GB
C. 400 GB
D. 500 GB
Answer: B

Network Appliance기출문제   NS0-502   NS0-502시험문제

NO.6 A 100-GB thinly provisioned LUN is allocated to a Windows host. 100 GB of data is written into the
LUN. The current capacity utilization on the disk array as well as the host is 100%. 50 GB of data is
deleted from the LUN. Space reclaimer has NOT been run.
What is the current capacity utilization on both the host and the disk array?
A. 50% on the host, 100% on the disk array
B. 100% on the host, 50% on the disk array
C. 50% on the host, 50% on the disk array
D. 100% on the host, 100% on the disk array
Answer: A

Network Appliance덤프   NS0-502시험문제   NS0-502최신덤프   NS0-502   NS0-502인증   NS0-502인증

NO.7 Click the Exhibit button.
Based on the diagram shown, what is the appropriate FC switch topology?
A. full mesh
B. core-edge
C. full cascade
D. partial mesh
Answer: B

Network Appliance인증   NS0-502자격증   NS0-502

NO.8 Which utility on Windows 2003 and Windows 2008 can be used to collect information about firmware
and driver versions for an Emulex LP1xxxx/LPe1xxx HBA?
A. EMutil
B. SANutil
C. fcp config
D. SANsurfer
E. HBAnywhere
Answer: E

Network Appliance덤프   NS0-502 dump   NS0-502

NO.9 Zoning by World Wide Port Name (WWPN) is deployed and a host HBA is replaced.
Which zone change needs to be made?
A. No changes are necessary.
B. The zone configuration should be changed to include the port to which the HBA is connected.
C. The zone configuration should be changed to include the WWPN of the new HBA; the old WWPN will
be automatically dropped.
D. The zone configuration should be changed to include the WWPN of the new HBA and to remove the
WWPN of the old HBA.
Answer: D

Network Appliance   NS0-502   NS0-502자격증   NS0-502자격증

NO.10 Click the Exhibit button.
Based on the diagram shown, what is the appropriate FC switch topology?
A. core-edge
B. full mesh
C. partial mesh
D. partial cascade
Answer: C

Network Appliance최신덤프   NS0-502 dumps   NS0-502   NS0-502   NS0-502

NO.11 Click the Exhibit button.
Given the information provided in the diagram, what is the appropriate FC topology?
A. point-to-point
B. switched fabric
C. arbitrated loop
D. ring
Answer: B

Network Appliance   NS0-502덤프   NS0-502덤프   NS0-502

NO.12 Click the Exhibit button.
You see the following error on the storage controller's console or messages file.
What is the most likely cause for this error?
A. portal group misconfiguration
B. iSCSI CHAP misconfiguration
C. iSNS misconfiguration
D. IPsec misconfiguration
Answer: B

Network Appliance자격증   NS0-502   NS0-502기출문제   NS0-502

NO.13 Which FC SAN topology provides the best performance and scalability?
A. cascade
B. core-edge
C. full mesh
D. partial mesh
Answer: B

Network Appliance   NS0-502덤프   NS0-502자격증

NO.14 What would you use to share a data LUN among multiple servers where each server has simultaneous
write access?
A. host-based BootBIOS
B. host-based multipathing
C. host-based volume manager
D. host-based clustered file system
Answer: D

Network Appliance dumps   NS0-502   NS0-502   NS0-502   NS0-502자격증   NS0-502 dump

NO.15 A customer has a four-node SUN cluster configuration. Each node has two, dual-ported HBAs.
What is the minimum number of igroups that need to be created to map a LUN to the cluster?
A. 1
B. 2
C. 4
D. 8
Answer: A

Network Appliance기출문제   NS0-502   NS0-502 dumps   NS0-502

NO.16 Any newly installed system with Data ONTAP 7.3.1 supports which cfmode?
A. dual_fabric only
B. single_image
C. partner
D. mixed
Answer: B

Network Appliance시험문제   NS0-502   NS0-502   NS0-502 dump   NS0-502

NO.17 Which utility on Solaris 10 can be used to collect information about firmware and driver versions for an
Emulex LP1xxxx/LPe1xxxx HBA?
A. EMutil
B. SANutil
C. hbainfo
D. SANsurfer
E. HBAnywhere
Answer: E

Network Appliance   NS0-502   NS0-502

NO.18 Click the Exhibit Button
The table highlights the space management policy that is defined for a particular flexvol, acmevol.
Based on the information provided in the table, which action will the storage controller take when it runs
out of space in the volume?
A. It will try deleting Snapshot copies first to reclaim space before trying to grow the volume.
B. It will grow the volume before deleting Snapshot copies.
C. It will only try deleting Snapshot copies to reclaim space and will not grow the volume.
D. It is irrelevant since fractional_reserve is 0%.
Answer: C

Network Appliance   NS0-502   NS0-502

NO.19 Click the Exhibit button.
In the diagram shown, a portset is created on controller 1 with the command: controller1>portset create -f
ntapportset 0b. This portset is bound to the igroup with all the initiators in it.
How many paths can host 1 see to a LUN on controller 1?
A. six paths
B. four paths
C. eight paths
D. two paths
Answer: D

Network Appliance   NS0-502   NS0-502덤프   NS0-502기출문제

NO.20 Which utility on Solaris 10 can be used to collect information about firmware and driver versions for a
Qlogic QLAxxx/QLExxxx HBA?
A. EMutil
B. SANutil
C. cfgadmin
D. SANsurfer
E. HBAnywhere
Answer: D

Network Appliance자격증   NS0-502   NS0-502시험문제   NS0-502

ITExamDump의Network Appliance인증 NS0-502덤프는 시험패스율이 거의 100%에 달하여 많은 사랑을 받아왔습니다. 저희 사이트에서 처음 구매하는 분이라면 덤프풀질에 의문이 갈것입니다. 여러분이 신뢰가 생길수 있도록ITExamDump에서는Network Appliance인증 NS0-502덤프구매 사이트에 무료샘플을 설치해두었습니다.무료샘플에는 5개이상의 문제가 있는데 구매하지 않으셔도 공부가 됩니다. Network Appliance인증 NS0-502덤프로Network Appliance인증 NS0-502시험을 준비하여 한방에 시험패하세요.