ITExamDump를 선택함으로 여러분은 Citrix 인증1Y0-350시험에 대한 부담은 사라질 것입니다.우리 ITExamDump는 끊임없는 업데이트로 항상 최신버전의 Citrix 인증1Y0-350시험덤프임을 보장해드립니다.만약 덤프품질을 확인하고 싶다면ITExamDump 에서 무료로 제공되는Citrix 인증1Y0-350덤프의 일부분 문제를 체험하시면 됩니다.ITExamDump 는 100%의 보장도를 자랑하며Citrix 인증1Y0-350시험을 한번에 패스하도록 도와드립니다.
ITExamDump을 선택함으로 100%인증시험을 패스하실 수 있습니다. 우리는Citrix 1Y0-350시험의 갱신에 따라 최신의 덤프를 제공할 것입니다. ITExamDump에서는 무료로 24시간 온라인상담이 있으며, ITExamDump의 덤프로Citrix 1Y0-350시험을 패스하지 못한다면 우리는 덤프전액환불을 약속 드립니다.
우리는 여러분이 시험패스는 물론 또 일년무료 업데이트서비스를 제공합니다.만약 시험에서 실패했다면 우리는 덤프비용전액 환불을 약속 드립니다.하지만 이런 일은 없을 것입니다.우리는 우리덤프로 100%시험패스에 자신이 있습니다. 여러분은 먼저 우리 ITExamDump사이트에서 제공되는Citrix인증1Y0-350시험덤프의 일부분인 데모 즉 문제와 답을 다운받으셔서 체험해보실 수 잇습니다.
Citrix인증 1Y0-350시험은 인기있는 IT자격증을 취득하는데 필요한 국제적으로 인정받는 시험과목입니다. Citrix인증 1Y0-350시험을 패스하려면 ITExamDump의Citrix인증 1Y0-350덤프로 시험준비공부를 하는게 제일 좋은 방법입니다. ITExamDump덤프는 IT전문가들이 최선을 다해 연구해낸 멋진 작품입니다. Citrix인증 1Y0-350덤프구매후 업데이트될시 업데이트버전을 무료서비스료 제공해드립니다.
Citrix 1Y0-350인증시험은 전문적인 관련지식을 테스트하는 인증시험입니다. ITExamDump는 여러분이Citrix 1Y0-350인증시험을 통과할 수 잇도록 도와주는 사이트입니다. 많은 분들이 많은 시간과 돈을 들여 혹은 여러 학원 등을 다니면서Citrix 1Y0-350인증시험패스에 노력을 다합니다. 하지만 우리ITExamDump에서는 20시간 좌우만 투자하면 무조건Citrix 1Y0-350시험을 패스할 수 있도록 도와드립니다.
Citrix인증 1Y0-350시험은 IT인증시험중 가장 인기있는 시험입니다. Citrix인증 1Y0-350시험패스는 모든 IT인사들의 로망입니다. ITExamDump의 완벽한 Citrix인증 1Y0-350덤프로 시험준비하여 고득점으로 자격증을 따보세요.
시험 번호/코드: 1Y0-350
시험 이름: Citrix (Citrix NetScaler 10 Essentials and Networking)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 126 문항
업데이트: 2014-04-27
ITExamDump의 경험이 풍부한 전문가들이Citrix 1Y0-350인증시험관련자료들을 계획적으로 페펙트하게 만들었습니다.Citrix 1Y0-350인증시험응시에는 딱 좋은 자료들입니다. ITExamDump는 최고의 덤프만 제공합니다. 응시 전Citrix 1Y0-350인증시험덤프로 최고의 시험대비준비를 하시기 바랍니다.
1Y0-350 덤프무료샘플다운로드하기: http://www.itexamdump.com/1Y0-350.html
NO.1 A network engineer wants to optimize a published load balanced SSL virtual server for WAN
connection with long delay, high bandwidth with minimal packet drops.
What would the network engineer use to do this type of optimization for the SSL virtual server?
A. SSL policy
B. TCP profile
C. Compression policy
D. Priority queuing policy
Answer: B
Citrix 1Y0-350 1Y0-350 1Y0-350
NO.2 Scenario: A network engineer created an IPv6 virtual server on the NetScaler. The virtual
server is using a service group with two IPv4 servers bound to it. When testing access to the virtual
server from a client configured with an IPv6 address, he is unable to connect.
What could be the reason for this issue?
A. The NetScaler is disabled for NAT.
B. IPv6 protocol translation is disabled.
C. An IPv6 address on the NetScaler is not bound to the correct VLAN.
D. The NetScaler does not have an INAT rule to convert IPv4 to IPv6 from the back-end servers.
Answer: B
Citrix 1Y0-350 1Y0-350덤프 1Y0-350자격증
NO.3 Scenario: A NetScaler appliance currently has a manually configured channel containing four
interfaces; however, the engineer has been told that the NetScaler must now only use a single
interface for this network. The engineer removes the channel and immediately notices a decrease in
network performance.
How could the engineer resolve this issue?
A. Reset the unused interfaces
B. Disable the unused interfaces
C. Enable flow control on all interfaces
D. Disable HA monitoring on the three interfaces that are no longer required
Answer: B
Citrix자격증 1Y0-350 dumps 1Y0-350
NO.4 A network engineer has configured two NetScaler MPX appliances as a high availability (HA)
pair.
What can the engineer configure to prevent failover if only a single interface fails?
A. FIS
B. PBR
C. SNMP
D. VMAC
Answer: A
Citrix 1Y0-350인증 1Y0-350 1Y0-350시험문제 1Y0-350
NO.5 Scenario: A NetScaler engineer needs to enable access to some web servers running on an
IPv6-only network. The clients connecting the services are on an IPv4 network. The engineer has
already enabled IPv6 on the NetScaler.
What does the engineer need to do in order to provide access to the services on the IPv6 network?
A. Create an IPv6 tunnel and a IPv4 virtual server.
B. Configure an IPv6 VLAN and bind the required interface.
C. Create a IPv4 virtual server and bind the service group to it.
D. Create an IPv6 ACL and a IPv4 virtual server and bind the ACL to the virtual server.
Answer: C
Citrix 1Y0-350 1Y0-350 dump 1Y0-350 1Y0-350 1Y0-350
NO.6 Scenario: For security reasons, the NSIP needs to be configured to only be accessible on
interface 0/1, which is VLAN 300.
The NSIP address is 10.110.4.254 and the subnet mask is 255.255.255.0.
How would the network engineer achieve this configuration?
A. set ns config -nsvlan 300 -ifnum 0/1
B. set ns ip 10.110.4.254 -gui ENABLED -vrID 300
C. add vlan 300 set ns ip 10.110.4.254 -mgmtAccess ENABLED
D. set ns config -IPAddress 10.110.4.254 -netmask 255.255.255.0
Answer: A
Citrix자료 1Y0-350 dumps 1Y0-350덤프 1Y0-350
NO.7 Scenario: The NetScaler is connected to two subnets. The NSIP is 10.2.9.12. The external SNIP
is 10.2.7.3. The MIP for internal access is 10.2.9.3. Web servers, authentication servers and time
servers are on the 10.2.10.0/ 24 network which is available through the
10.2.9.1 router. The external firewall has the 10.2.7.1 address. Traffic bound for Internet clients
should flow through the external firewall.
Which command should be used to set the default route?
A. add route 0.0.0.0 0.0.0.0 10.2.7.1
B. add route 0.0.0.0 0.0.0.0 10.2.9.1
C. add route 10.0.0.0 255.0.0.0 10.2.9.1
D. add route 10.0.0.0 255.0.0.0 10.2.7.1
Answer: A
Citrix 1Y0-350 1Y0-350시험문제 1Y0-350 1Y0-350 dumps
NO.8 Scenario: The NetScaler has connections to a large number of VPNs. The network engineer
wants to minimize the number of ARP requests.
Which feature should the network engineer enable to minimize ARP requests?
A. TCP Buffering
B. Use Source IP
C. Edge Configuration
D. MAC based forwarding
Answer: D
Citrix 1Y0-350 1Y0-350기출문제 1Y0-350인증
NO.9 Scenario: An engineer executes the following commands:
add vlan 2 bind vlan 2 -ifnum 1 / 2 add ns ip 10.110.4.200 255.255.255.0 bind vlan 2 -IPAddress
10.110.4.200 255.255.255.0
What type of IP address has been added to the NetScaler?
A. VIP address
B. NSIP address
C. SNIP address
D. GSLB Site IP address
Answer: C
Citrix pdf 1Y0-350기출문제 1Y0-350 1Y0-350 1Y0-350
NO.10 Why would an engineer want to specify a TCP Profile for a specific service group?
A. To enable use of features like SSL over TCP for that specific service group.
B. To adjust the TCP settings for traffic to and from that specific service group.
C. To use a specific SNIP for traffic to the back-end servers in that service group.
D. To enable features like use source IP , TCP keep alive and TCP buffering for a specific service group.
Answer: B
Citrix덤프 1Y0-350덤프 1Y0-350 1Y0-350
ITexamdump의 C_A1FIN_10덤프의 VCE테스트프로그램과 MB2-700덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 642-996시험에 대비한 고품질 덤프와 HP2-N43시험 최신버전덤프를 제공해드립니다. 최고품질 642-874시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기