Cisco 인증 350-021 덤프

ITExamDump의Cisco인증 350-021덤프는 몇십년간 IT업계에 종사한 전문가들이Cisco인증 350-021 실제 시험에 대비하여 제작한 시험준비 공부가이드입니다. Cisco인증 350-021덤프공부가이드로 시험준비공부를 하시면 시험패스가 쉬워집니다. 공부하는 시간도 적어지고 다른 공부자료에 투자하는 돈도 줄어듭니다. ITExamDump의Cisco인증 350-021덤프는 Cisco인증 350-021시험패스의 특효약입니다.

ITExamDump는ITExamDump의Cisco인증 350-021덤프자료를 공부하면 한방에 시험패스하는것을 굳게 약속드립니다. ITExamDump의Cisco인증 350-021덤프로 공부하여 시험불합격받으면 바로 덤프비용전액 환불처리해드리는 서비스를 제공해드리기에 아무런 무담없는 시험준비공부를 할수 있습니다.

영어가 서툴러 국제승인 인기 IT인증자격증 필수시험 과목인Cisco인증 350-021시험에 도전할 엄두도 낼수 없다구요? 이런 생각은 이글을 보는 순간 버리세요. Cisco인증 350-021시험을 패스하려면ITExamDump가 고객님의 곁을 지켜드립니다. ITExamDump의Cisco인증 350-021덤프는 Cisco인증 350-021시험패스 특효약입니다. 영어가 서툴러고 덤프범위안의 문제만 기억하면 되기에 영어로 인한 문제는 걱정하지 않으셔도 됩니다.

ITExamDump의 Cisco인증 350-021시험덤프는 고객님의 IT자격증을 취득하는 꿈을 실현시켜 드리는 시험패스의 지름길입니다. Cisco인증 350-021덤프에는 실제시험문제의 거의 모든 문제를 적중하고 습니다. ITExamDump의 Cisco인증 350-021덤프가 있으면 시험패스가 한결 간편해집니다.

시험 번호/코드: 350-021

시험 이름: Cisco (CCIE SP Cable Qualification Exam)

350-021 덤프무료샘플다운로드하기: http://www.itexamdump.com/350-021.html

NO.1 Unity gain is being used for alignment. The first amplifier from the node has 25 dB of gain and is 2000
feet away with cable loss of 1 dB per 100 feet. The node has an output of 35 dBmV at 55.25 MHz. What is
the input at the amplifier?
A. 13dBmV
B. 3dBmV
C. 15dBmV
D. 27dBmV
Answer: C

Cisco   350-021   350-021 pdf   350-021자격증

NO.2 For an OC-48 signal (2.5Gb/s), what is the BER (bit error rate) if there is 1 bit error every four days?
A. 10E-12
B. 10E-13
C. 10E-14
D. 10E-15
E. 10E-16
Answer: D

Cisco최신덤프   350-021   350-021 pdf   350-021

NO.3 The name of the DOCSIS config file to download will be offered to the cable modem in what DHCP
field?
A. giaddr
B. config-filename
C. packet-filename
D. siaddr
Answer: C

Cisco인증   350-021시험문제   350-021   350-021

NO.4 For communications systems what describes the over-all health of the system?
A. Bit-Error-Rate (BER)
B. Synchronous Optical NETwork (SONET)
C. Optical Signal to Noise Ratio (OSNR)
D. None of the above
Answer: A

Cisco dump   350-021최신덤프   350-021자격증   350-021   350-021

NO.5 HFC cable television return path networks are aligned to provide: (multiple answer)
A. Asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. Unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed value
attenuator and equalizer at the output stage in each of the return amplifiers in the network
C. Unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed value
attenuator and equalizer at the input stage of each of the return amplifiers in the network
D. Cable modems the ability to power range comfortably within their output power dynamic range
E. It is not necessary to align the return path amplifiers since the CMTS will automatically adjust the cable
modem transmit power levels.
Answer: BD

Cisco   350-021인증   350-021 dumps   350-021   350-021

NO.6 What is NOT an ATM class of service?
A. CBR
B. VBR-t
C. ABR
D. UBR
E. CAR
Answer: E

Cisco   350-021   350-021인증   350-021

NO.7 A router is set to boot from flash, but cannot find boot commands in the configuration. Also, valid files
do not exist in the default flash device. The router will:
A. Boot from ROM, since there are no valid sources
B. Try to boot from the network, using a default filename
C. Terminate the boot process with an error message
D. Try to boot from the network, then boot from ROM as a backup
Answer: D

Cisco   350-021최신덤프   350-021 dump   350-021

NO.8 What describes a technique, used to encapsulate voice (NOT data) over ATM?
A. RFC 1483
B. LANE
C. AAL-1
D. RFC 1577
Answer: C

Cisco   350-021최신덤프   350-021

NO.9 Which are HFC cable television forward path networks aligned to provide? (multiple answer)
A. For asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. For unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed
value attenuator and equalizer at the output stage in each of the forward amplifiers in the network
C. For unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed
value attenuator & equalizer at the input stage of each of the forward amplifiers in the network
D. It is not necessary to align the forward path amplifiers since the CMTS will automatically compensate
for forward path gain discrepancies.
E. For unity gain and are level compensated by automatic gain and slope control systems utilizing RF pilot
reference carriers
Answer: CE

Cisco   350-021   350-021 dumps   350-021   350-021최신덤프

NO.10 What is the purpose of rate decoupling for ATM transmission?
A. It provides transparency between SONET and SDH.
B. It converts higher-speed DS3/E3 to lower-speed optical rates.
C. It processess the packing and unpacking of frames into 53-octet cells.
D. It allows lower-speed traffic on an ATM facility without causing traffic gaps.
Answer: D

Cisco자격증   350-021   350-021

NO.11 There are two different headends with two different frequencies available sharing the same plant.
There is a -10dB cable loss to the second active in the cascade. What is the required pad for balancing
A. A 0 pad
B. A 1 pad
C. A 2 pad
D. A 3 pad
E. A 4 pad
F. A 5 pad
Answer: F

Cisco dump   350-021 dumps   350-021 dumps   350-021 dump   350-021

NO.12 In a cable HFC plant, which devices are modulators? (multiple answer)
A. CMTS line card
B. Upconverter
C. Diplex filter
D. Set top box
E. Fiber node
Answer: AD

Cisco   350-021덤프   350-021   350-021덤프

NO.13 Cisco recommends the use of a headend-grade coaxial cable or a quad-shield coaxial cable with a
minimum of 60% + 40% braid and double foil insulation to connect the cable modem cards to the HFC
network. The center conductor must be straight and extend 1/8 inch (3.2 mm) beyond the end of the
connector, and the connector should be securely crimped to the cable. Select three recommended cable
types that can be used to connect the Cisco uBR7200 series universal broadband routers: (multiple
answer)
A. RG 58
B. RG 59
C. RG 59/U
D. RG 6
E. RG 7
Answer: BCD

Cisco   350-021자격증   350-021

NO.14 Upon deleting an IOS image file from flash, an execution of show flash shows the file still in flash, with
a 'D' preceding it (as shown in the exhibit). What step must be taken in order to remove the file
completely?
A. Erase the file from flash
B. Format the flash device
C. Replace the flash card - it is defective
D. Execute a squeeze command on the flash device
Answer: D

Cisco자격증   350-021   350-021   350-021 dump

NO.15 Every time a typing mistake is made at the exec prompt of a router, the message from the router
indicates a lookup is being performed. Also, there is a waiting period of several seconds before the next
command can be typed. Can this behavior be changed?
A. No, this is a built in feature of Cisco IOS? software.
B. Yes, use the no ip domain-lookup command.
C. Yes, use the no ip helper-address command.
D. Yes, use the no ip multicast helper-map command.
E. Yes, use the no exec lookup command.
Answer: B

Cisco인증   350-021   350-021자료   350-021최신덤프

NO.16 If there are two different headends with two different frequencies available sharing the same plant, what
frequency will the two groups of cable modems, which are brand new, and have never been on-line, lock
on?
A. They will lock on the frequency configured on the linecard.
B. They will lock on the frequency configured on the upconverter.
C. They will lock on the first frequency they find.
D. They will lock on the lowest frequency.
E. They will lock on the last frequency remembered in ram.
Answer: C

Cisco시험문제   350-021자격증   350-021   350-021   350-021

NO.17 Given a PAL HFC and 8 MHz channel lineup in the downstream, is it possible to utilize 6 MHz DOCSIS
cable modems and signals on the network?
A. No, only 8 MHz channel spacing is available for Downstream data signals
B. Yes, as long as the 6 MHz DOCSIS signal is within a valid 8 MHz channel
C. Yes, as long as the DOCSIS signal is upconverted through a PAL upconverter
D. No, DOCSIS cannot be mixed with EuroDOCSIS in the Donwstream
E. DOCSIS must be used only in an EIA-542 channel plans
Answer: B

Cisco   350-021   350-021   350-021

NO.18 A network administrator is using debug commands to check the performance of a network. What steps
can the administrator take to ensure that the "debug" will not require too much CPU, or at least that she
will not have to reboot the router to disable debug? (multiple answer)
A. Make the debug command as specific as possible
B. Use the max-time parameter of the debug command
C. In configuration mode, enter scheduler interval 15
D. Configure a loopback to channel debug traffic
Answer: AC

Cisco   350-021   350-021 dumps   350-021   350-021기출문제   350-021

NO.19 A DOCSIS 2-way data system is being designedto limit upstream traffic. Unknown modems should be
kept from using precious Upstream bandwidth. Given these requirements, it should beensured that the
DOCSIS configuration file has what set?
A. Vendor-specific information field
B. Max-cpe should be set to 1
C. CMTS authentication field should be set
D. Network Access should be set to 0
E. Downstream frequency should be set above 450 MHz
Answer: D

Cisco인증   350-021   350-021 pdf   350-021최신덤프   350-021자료   350-021

NO.20 What effect will this configuration command have?
line vty 0 4
no password vtypassword
A. All telnet connections to the router will be denied.
B. Only one telnet connection at the router will be allowed at a time.
C. Virtual terminal sessions will not be able to enter enable mode.
D. Virtual terminal sessions will not be asked a user-level password.
E. It will have no effect.
Answer: A

Cisco dump   350-021   350-021자격증   350-021최신덤프   350-021

ITExamDump는 고객님의 IT자격증취득의 작은 소원을 이루어지게 도워드리는 IT인증시험덤프를 제공해드리는 전문적인 사이트입니다. ITExamDump 표 Cisco인증350-021시험덤프가 있으면 인증시험걱정을 버리셔도 됩니다. ITExamDump 표 Cisco인증350-021덤프는 시험출제 예상문제를 정리해둔 실제시험문제에 가장 가까운 시험준비공부자료로서 공을 들이지않고도 시험패스가 가능합니다.